Track Pans - 3” Drain Fitting For Below Grade Piping Part #9559

120 gallons-per-minute (gpm).

Is it though? When you simply compare the cost per foot (or inch), then yes, it is cheaper. But when you take a closer look and consider how much more Ultra-Filter-Tex absorbs, you will quickly see that not only is Ultra-Filter-Tex the better choice from a performance standpoint but it is also the better choice from a cost standpoint. Take a look at this example.

Without grates, each center track pan holds 30 gallons and each side track pan holds 25 gallons. Each track pan grate displaces 6 gallons of fluid. Therefore, each center track pan with grates holds 18 gallons and each side track pan with grates holds 19 gallons.

Ultra-Track Pans are connected together with bulkhead fittings. One (1) bulkhead fitting is used to connect each side track pan “end to end” and two (2) bulkhead fittings are used to connect each center track pan “end to end.” The patented bulkhead fitting design allows spilled fluids to travel from one pan to the next, thereby increasing capacity as the spill travels over the length of the Ultra-Track Pan system.

Ultra-Track Pans are virtually maintenance-free. Visual inspection of the sealing gaskets located between the rails and pans should take place every six (6) months.

The gaskets that seal between the pans and tracks are closed-cell polyethylene (LLDPE) foam. The closed-cell material will not soak up any fluid.

All of these items are made of polyethylene. Coupled with the polyethylene (LLDPE) track gaskets, the Ultra-Track Pan product line offers consistent chemical compatibility.

Note: Standard gaskets for the bulkhead fittings are EPDM—other materials are available if necessary.